|
|
| Mark the bolt positions on the root rib | File out small notches. Check for correct location. |
|
|
| Join the halves, drill 5 mm holes (support equally wing tips) | Draw the pattern with ball point pen, cut out w. sharp knife |
|
|
| Soak with epoxy | Lay down, cover with adhesive tape |
|
|
| Remove both layers of tape when dry | Cut off the carbon/tape circles |
|
|
| Drill the hole for launching peg | Soak, lay down, cover with tape |
|
|
| The same for canopy lock | Rx-wing servo extension wire |
|
|
| Micropushrods outlet | |
|
|
| Rudder pushrod | Elevator pushrod |
|
|
| Aileron servos | Aileron servos |